GE MONOGRAM ZV1050 Installation Instructions Manual

Also see for Monogram ZV1050: Use and care guide Owner's manual Owner's manual Owner's manual Owner's manual

Contents

13Installation InstructionsSTEP 8 INSTALL DECORATIVE DUCT COVERS• Pretap or drive decorative screw into the screwholes on the support frame. This will make screwinstallation easier.• Separate the two decorative duct covers.• Select the inside cover (top), which has two screwholes in the top.• Slide the decorative duct cover over the support frameand push to the ceiling.• Attach to the hood support at the top with 2 supplieddecorative screws.• Locate the third decorative screw in the hardwarepackage. Set aside.• Slide the lower decorative duct over the installed upperduct and push to the top, keeping the bottom slottedhole to the left.• Install the decorative stop screw in the center hole ofthe upper (inner) duct cover. The decorative screw willact as a stop screw and prevent the lower decorativeduct cover from sliding down.CAUTION: The stop screw must beinstalled. Failure to do so could result in personal injuryor damage to the duct cover.PRUDENCE : La vis supérieuredoit être en place, afin d’éviter les blessures oud’endommager le capot antipoussière.STEP 9 INSTALL HOODNOTE: AT LEAST THREE PEOPLE ARE REQUIREDTO COMPLETE THIS INSTALLATION!• Lift the hood up to the support frame. Carefully alignthe hood mounting holes to the support frame holesand, at the same time, the hood duct connector intothe duct.• Install screws through the hood and hood support.• Check hood level in both directions.• Check to be sure that the duct is positioned over thehood connector.• Seal the duct connection with duct tape.NOTE: Do not drive screws through this ductconnection. Doing so will prevent proper damperoperation.Stop ScrewApply Duct Tapeto Seal DuctConnectionInstall4 Lock Washersand 4 Machine BoltsBottomDuctCover

/ 16

Related manuals for GE Monogram ZV1050