GE MicroCal iTC200 Operating Instructions Manual

MicroCal iTC 200 Operating Instructions 28-9639-77 AA 27Installation 3Site requirements 3.13 InstallationThis section provides information about the installation of MicroCal iTC200.Figure 3-1. MicroCal iTC200 with washing module and control computer..Any equipment connected to the MicroCal iTC200 must fulfill applicable standards andlocal regulations.3.1 Site requirementsThe MicroCal iTC200 with Controller requires about 1 meter of normal bench space (ca.70 cm wide). This location should be away from strong drafts, room temperaturefluctuations, intense sunlight, vibrations and strong electrical or magnetic fields (asmay be produced by an NMR, microwave oven, large motors or refrigeration units). Inaddition the mains power source (100 to 240 VAC) should be properly grounded and freefrom voltage fluctuations, harmonic distortions, power dips and spikes. The AC powerline should be dedicated to the MicroCal iTC200 system and should not share that powerwith additional equipment.NOTICEIt is recommended that the installation of the MicroCal iTC200 instrumentbe performed by GE Healthcare personnel.