GE Monogram ZEW145 Use And Care & Installation Manual

Also see for Monogram ZEW145: Use and care guide Installation instructions

HALOGEN/RADIANT SURFACE UNIT CONTROLSHalogen Surface UnitThe controls selected for the halogenhadiantcomponent will give you a full range of heat settingsfor cooking.The control knobs must be pushed down to turnfrom the off (0) position. When the control knobsare in any position other than off(0), they may beturned without pushing down.You may notice that the knob that operates thehalogen surface unit is slightly harder to turn thanthe knob for the radiant surface unit. This is dueto the difference in design between the two controls.NOTE:. The lowest three settings will produce no visibleevidence of the surface unit being on although upto 11% of the total wattage is being generated. Onthe lowest settings, the percentage of power maynot cause the hot surface lights to light. An indicatorlight near the control knobs will glow when eithersurface unit is on.l The burner “on” light will glow for all positionsexcept the off position.The eleven position halogen control produces thefollowing variation in cooking power.SwitchSettingsL HIPosition10I ‘: I OFF1Brightnessof LampFullHighHighMediumMediumLowLowInvisibleInvisibleInvisibleInvisibleTypical HeaterPower (Yo)10076564130231611850If the halogen/radiant component is connected to 208volts, you will notice some increase in cooking times.Radiant Surface UnitThe control for the radiant surface unit is an infiniteswitch that can be set anywhere between LO and HIfor an unlimited number of heat settings.Wxth theinfinite switch the coil cycles on and off to maintainyour selected control setting.The control knobs must be pushed down to turnfrom the off (0) position. When the control knobsare in any position other than off(0), they may beturned without pushing down.Be sure you turn the conrol knob off(0) whenyou finish cooking. You will feel a “click” at theoff position.11