GAS BURNER CONTROLSSee the Gas Burner Component section.The gas burnercontrols must tum counterclockwiseto the LITE position to ignite the burner.Once the burner is ignited, turn the control knobcounterclockwise to adjust the flame lower. Asparking sound caused by the igniter is normaluntil ignition occurs.The burners will relight at any setting. However, forthe burners to light quickly and consistently when thegas is turned on, the knobs should be turned to theLITE position until ignition occurs.When turning the control knob to off (0), turnit clockwise.GRILL/GRIDDLECONTROLSSee both the Grill Component and the GriddleAccessory sections. Also see the Grill Cooking andthe Griddle Cooking Guides.Most cooking on the ~till or griddle is done at the HIsetting. See the Grill Component section regardingflame-ups and the control settings for this emergency.Each half of the grill component is controlledseparately.The control knob labeled GRIDDLE controls theentire griddle accessory.The GRILIJGRIDDLE controls turn either directionto adjustthe heat setting.VENT SYSTEM CONTROLTo operate the vent system manually, turn the knob onthe control panel clockwise to the desired blower speed.Use the control knob at the front of the vent ~tille to~ladjust the blower speed. The control knob may be in a lcustom location in the counter cabinet front. A HI Bo” “setting is recommended when flame-ups occur while * lcooking on the ~till. l lThe downdraft blower adjacent to the till comes onautomatically when the ~till is turned on. It turns offautomatically when the ~till or ~tiddle is turned off (0).If the blower speed is adjusted while ~tilling,the blower will not turn off automatically andmust be turned off manually.The built-in vent system helps remove cookingvapors, odors and smoke from foods prepared onthe cooktop modules.12