GE Monogram ZGG420LBPSS Owner's Manual

Also see for ZX27AD: Installation instructions

Contents

Infraredsearburner(on somemodels)After each use, it is important to operate theburner on HI for 5 minutes with the hood opento burn away any food particles or drippings.Some ash may accumulate on the burner surfaceover time. Occasionally brush, blow or vacuumthe debris from the surface of the burner. Onlyperform this operation when the burner iscompletely cool.NOTICE: To prevent damage to the burner:• Always make sure that the protective screenis properly in place on the infrared burner.• Never allow water to contact the infraredburner.Cooktopburnergrates(on somemodels)The enameled cast-iron burner grates should becleaned regularly.Wash them in hot soapy water, rinse and drythoroughly.The grates can also be cleaned inside an ovenduring a self-clean cycle, or in a dishwasher. Theframes may be cleaned by hand or inthe dishwasher.Although they are durable, the grates may dullover time, regardless of the best care you cangive them. This is due to their continual exposureto high temperatures.Do not operate a burner for an extendedperiod of time without cookware on the grate.The finish on the grate may chip withoutcookware to absorb the heat.For stability, the frames have rubber pads oneach corner. During cleaning and use, be carefulnot to damage or snag rubber pads.Grates (reversiblefor wok cooking)FramePadsInfrared sear burnerwith protective screenGrilllight(s) CAUTION: Allow the grill and lightassembly to cool completely before replacing.For your safety, do not touch a hot bulb withbare hands or a damp cloth.Each grill is equipped with a halogen light(s)located above the warming shelf.The light assembly consists of a removable glasslight cover and a locking clip.To remove:1. Remove the light cover by pulling its rightedge down. NOTE: The locking clip may fallfrom the light cover. It will need to bereplaced properly.2. Using gloves or a dry cloth, remove theburned-out bulb by pulling it straight out.To replaceUse a new 12-volt halogen bulb, with G4 base,not to exceed 10 watts. IMPORTANT: Higherwattage bulbs will blow the fuse. See the FuseReplacement section.Replacement bulbs may be purchased by calling800.626.2002. Order Part Number WB08X10060.1. Using gloves or a dry cloth, remove bulb fromits packaging. Do not touch bulb with barefingers. Push bulb straight into receptacle allthe way.2. Place left edge of cover under retaining tab.Roll right side up making sure that the clipseats in place. NOTE: If the locking clip fellfrom the cover, hold it in place on the coverwhile replacing.Cover must always be in place when using grill.Clean the cover frequently using a wet cloth.This should be done when the grill is completelycool. 25Locking clipRetaining tab