GE PCGS910 Owner's Manual

GE PCGS910 Owner's Manual Manual pdf 15 page image

Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportTo Set the ClockThe clock must be set to the correct timeof day for the automatic oven timingfunctions to work properly. The time ofday cannot be changed during a timedbaking or self-cleaning cycle.Touch the CLOCK pad.Touch the number pads.Touch the START pad.Make sure the clock is set to thecorrect time of day.To Set the TimerTouch the pad.TIMERTouch the number pads until theamount of time you want showsin the display. For example, to set2 hours and 45 minutes, touch 2, 4and 5 in that order. If you make amistake touch the pad andTIMERbegin again.Touch the START pad.After touching the START pad, SET disappears;this tells you the time is counting down, althoughthe display does not change until one minute haspassed. Seconds will not be shown in the displayuntil the last minute is counting down.When the timer reaches :00, thecontrol will beep 3 times followedby one beep every 6 seconds untilthe TIMER pad is touched.The 6-second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End of aTimed Cycle.The timer is a minute timer only.The timer does not control ovenoperations. The maximum setting onthe timer is 9 hours and 59 minutes.To Reset the TimerIf the display is still showing the timeremaining, you may change it bytouching the TIMER pad, then touchthe number pads until the time youwant appears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display), recall the remaining time bytouching the TIMER pad and thentouching the number pads to enter thenew time you want.To Cancel the TimerTouch the TIMER pad twice.15Your control will allow you to lock out the touchpads so they cannot be activated when touchedor while cleaning the glass panel.To lock/unlock the controls:Touch the 9 and 0 pads at the sametime for 3 seconds, until the controlbeeps twice. The display will showcontinuosly at the time of dayif not blanked outLOCTo unlock the control, touch the 9and 0 pads at the same time for 3seconds, until the display showsLOC .Control Lockout (only some models)Using the clock, timer and control lockout. www.GEAppliances.caNOTE: All cooking and timing functions will becancelled when locking out the control.CONTROL LOCNOTE: CONTROL LOCKOUT / GAS RANGE LOCKOUT / RANGELOCKOUT 3Some models have apad. Touch and hold it for secondsto lock/unlock.