GE PCGS910 Owner's Manual

GE PCGS910 Owner's Manual Manual pdf 34 page image

Oven Light BulbsNOTE: The glass cover should beremoved only when cold. Wearing latexgloves may offer a better grip.CAUTION: Before replacing youroven light bulb, disconnect the electricalpower to the oven at the main fuse orcircuit breaker panel.Be sure to let the light cover and bulbcool completely.For your safety, do not touch a hot bulbwith bare hands or a damp cloth.To remove:Turn the glass covercounterclockwise 1/4 turn until thetabs of the glass cover clear thegrooves of the socket.Using gloves or a dry cloth, removethe bulb by pulling it straight out.To replace:Use a new 130-volt halogen bulb,not to exceed 50 watts.Using gloves or a dry cloth, removethe bulb from its packaging. Do nottouch the bulb with bare fingers.Push the bulb straight into thereceptacle all the way.Place the tabs of the glass cover intothe grooves of the socket. Turn theglass cover clockwise 1/4 turn toengage.For improved lighting insidethe oven, clean the glass coverfrequently using a wet cloth. Thisshould be done when the oven iscompletely cool.Reconnect electrical power tothe oven.BulbSocketTabGlass coverUse glovesor clothReceptacleReceptacle34Care and cleaning of the range.Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsOven Light Replacement(on some models)To remove the cover:To replace the cover:Do not remove any screws to remove the cover.Be sure to let the light cover and bulbcool completely.Hold a hand under the cover soit doesn’t fall when relased. Withfingers of the same hand, firmlypush back the wire cover holder.Lift off the cover.Place it into groove of the lighttreceptacle. Pull wire forward tothe center of the cover until its snapsinto place.Connect electrical power to therange.Replace bulb with a 40-wattappliance bulb.Be sure all controls are off and all surfaces are cool before cleaning any part of the range.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is reengaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.How to Remove Protective Shipping Film and Packaging TapeCarefully grasp a corner of the protectiveshipping film with your fingers and slowlypeel it from the appliance surface. Donot use any sharp items to remove thefilm. Remove all of the film before usingthe appliance for the first time.To assure no damage is done to thefinish of the product, the safest way toremove the adhesive from packaging tapeon new appliances is an application of ahousehold liquid dishwashing detergent.Apply with a soft cloth and allow to soak.NOTE: The adhesive must be removed from allparts. It cannot be removed if it is baked on.