GE PHP900 Owner's Manual

Also see for Profile PHP900: Dimensions and installation information Dimensions and installation information Installation instructions Installation instructions Installation instructions

Contents

ge.com"H" indicates that the Boost powerlevel has been selected for rapidcooking and boiling.Boost SettingBoost isthe highest power level, designedfor large quantitg rapid cooking andboiling. Boost will operate for a maximumof 10 minutes. After 10 minutes, it willautomaticallg revert to power level9.Boost mag be repeated after the initial10 minute cgcle.CAUTION:Do not leave a pot unattendedwhile in the Boost Mode.Tostart the Boost power setting:[] Placea pan matching the size of theinduction element over the selectedindicator ring.[] Touch the ON/OFF pad. "5" will flashin the displag.[] Touch and hold the (+)pad until thedisplag reads "HI'NOTE:If the pan is removed, the displagwill flash "F" alternating to "H', After 30seconds, the elements will turn offautomaticallg.Sounds you may hear:You mag hear a slight "buzz"sound whencooking with the Boost or high mode. Thisis normal. The sound depends on the tgpeof pot being used. Some pots will "buzz"louder depending on the material. A "buzz"sound mag be heard if the pan contentsare cold. As the pan heats, the sound willdecrease. If the power level is reduced, thesound level will go down.Power SharingFour burner cooktops are divided into two separatei ii _ i ii4 burner cooktops with right and left side (2)induction generators.i iiiiii ii i)i _i _i_i _i _i_i _i _i_ i_ i_ i_ i_ i_ i_ i_i iiii:heating zones.The right and left side cooking zonesare powered bg separate and independent inductiongenerators. One generator controls 2 elements, or twocooking zones within a heating section share the powerof one generatoEFive burner cooktops are divided into 3 zones.Theright and left side have separate cooking zones and thelarge center element is another separate cooking zone.Power Sharing is activated when both elements in thesame cooking zone are activated and one element isset for Boost (H).The element that is not set for Boostwill change to a lower power level.This is calledPower Sharing.When Boost operation is complete(10 minutes),the other element mag be reset to angpower level. Both elements can operate simultaneouslgat normal power levelsettings of "L"to 9.IMPORTANT NOTE FOR FOUR BURNER MODELS:The elements on the right side shore one generoto_Both elements con operate at any non-Boost (level Lto 9) power level at the some time. If the large frontelement is set for "H" or Boost, the smaller elementat the right rear will be deactivated or turned offautomatically. The smaller right rear element con beactivated and set for any power level after the Boostoperation of the larger element is completed (10minutes).5 burner cooktops with right, left and center (3) induction generators.11