GE Profile PVM9005FMDS Installation Instructions Manual

Also see for Profile PVM9005 Series: Owner's manual Owner's manual Installation instructions

49-40755 Rev. 1 13Installation InstructionsRECIRCULATING (Non-Vented Ductless)INSTALLATION OVERVIEWA1. Attach Mounting Plate to WallA2. Prepare Top CabinetA3. Adjust Blower MotorA4. Install Charcoal FilterA5. Mount the microwave ovenA6. Installing/Replacing the Charcoal Filter WithoutAccess to Top Screws and the Unit HasAlready Been Mounted.AUSE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETA2• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on theTOP CABINET TEMPLATE.CAUTION Wear safety goggles when drillingholes in the cabinet bottom.You need to drill holes for the top support screws anda hole large enough for the power cord to fit through.Place the mounting plate against the wall andinsert the toggle wings into the holes in the wall tomount the plate.NOTE: Before tightening toggle bolts and woodscrew, make sure the tabs on the mounting platetouch the bottom of the cabinet or the horizontallevel line when pushed flush against the wall andthat the plate is properly centered under the cabinet.CAUTION Be careful to avoid pinchingfingers between the back of the mounting plateand the wall.Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.3ATTACH THE MOUNTINGPLATE TO THE WALLA1Attach the plate to the wall using toggle bolts. Atleast one wood screw must be used to attach theplate to a wall stud.Remove the toggle wings from the bolts.Insert the bolts into the mounting plate throughthe holes designated to go into drywall andreattach the toggle wings to 3»4s onto each bolt.14WallMountingPlateSpacing for Toggles MoreThan Wall ThicknessBolt EndToggleBoltToggle WingsTo use toggle bolts:2