GE Profile PVM9005FMDS Installation Instructions Manual

Also see for Profile PVM9005 Series: Owner's manual Owner's manual Installation instructions

22 49-40755 Rev.121 Remove the blower motor screws that holds theblower plate to the microwave oven. Slide the platetoward the back of the microwave and lift up toremove.ADAPTING BLOWER FOROUTSIDE BACK EXHAUSTC4Remove screw on the back of the unit.USE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETC3• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on theTOP CABINET TEMPLATE.CAUTION Wear safety goggles whendrilling holes in the cabinet bottom.WallMountingPlateSpacing for Toggles MoreThan Wall ThicknessToggleBoltToggle WingsTo use toggle bolts:BoltEndInstallation InstructionsYou need to drill holes for the top support screws anda hole large enough for the power cord to fit through.Place the mounting plate against the wall andinsert the toggle wings into the holes in the wall tomount the plate.NOTE: Before tightening toggle bolts and woodscrew, make sure the tabs on the mounting platetouchthe bottom of the cabinet when pushed flush againstthe wall and that the plate is properly centeredunder the cabinet.CAUTION Be careful to avoid pinchingfingers between the back of the mounting plateand the wall.Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.34BlowerPlateBlower Motor ScrewsThe fan needs to be turned 180 degrees to theright to be in the correct orientation, keepingthe blower part of the fan where the air comesout at the top of the fan. The wire needs to bereinsterted into the cage housing once it has beenoriented correctly.Remove the knockout plates in the back of theunit with snips.45Back of MicrowaveBack of MicrowaveKnockout plates: Snip all 4 webs oneach knockout panel and remove thePHWDONQRFNRXWVIRUUHDUDLUÀRZ3OHDVHremove any sharp edges created fromremoving the knockout plates.Fan BladesWires3ATTACH THE MOUNTINGPLATE TO THE WALL (cont.)C2ScrewCarefully remove fan from cavity. Remove the wirefrom the notch at the bottom of the fan after it isremoved from the cavity.