49-40755 Rev. 1 19Installation InstructionsMOUNT THE MICROWAVE OVENB5CAUTION To avoid the risk of personalinjury (back injury or other injuries due toexcessive weight of the microwave) or propertydamage, you will need two people to install thismicrowave.IMPORTANT: Do not grip or use handle duringinstallation.WARNING Risk of Electric Shock. Cancause injury or death: If installing unit withmetal countertops, cover the edge of the powersupply cord hole with the power supply cordbushing.IMPORTANT: If filler blocks are not used, casedamage may occur from overtightening screws.NOTE: When mounting the microwave, threadpower cord through hole in bottom of top cabinet.Keep it tight throughout Steps 1–3. Do not pinchcord or lift microwave oven by pulling cord.Lift microwave, tilt it forward, and hook slotsat back bottom edge onto four lower tabs ofmounting plate.Rotate front of microwave oven up againstcabinet bottom.12Power CordASSEMBLE AND INSTALLADAPTORB4Place the microwave oven in its upright position,with the top of the unit facing up and the front of theunit facing toward you.Remove the screw on the back side of theblower plate and raise the blower plate off of themicrowave.Slide the damper from left to right into the tabs onthe blower plate. The yellow tape on the dampershould be facing away from you.Remove the yellow tape from the damper. Makesure that the damper pivots easily beforemounting microwave oven.You will need to make adjustments to assureproper alignment with your house exhaust ductafter the microwave oven is installed.Position the blower plate with damper back on themicrowave and secure it with the screws that wereremoved.12345DamperBlowerPlate