GE Profile PVM9005FMDS Installation Instructions Manual

Also see for Profile PVM9005 Series: Owner's manual Owner's manual Installation instructions

49-40755 Rev. 1 9Installation InstructionsFind the studs, using one of the following methods:A. Stud finder.ORB. Use a hammer to tap lightly across the mountingsurface to find a solid sound. This will indicatea stud location.After locating the stud(s), find the center by probingthe wall with a small nail to find the edges of thestud. Then place a mark halfway between theedges.7KHFHQWHURIDQ\DGMDFHQWVWXGVVKRXOGEHƎRUƎIURPWKLVPDUNDraw a line down the center of the studs.IMPORTANT: The microwave must be connected toat least one wall stud.1Open the box and fold back all four carton flapsfully against the carton sides. Remove the followingitems from the protective foam: installationinstructions, filters, exhaust adaptor, damper, andthe small hardware bag. Do not remove the foamprotecting the front of the microwave oven.Then carefully roll the microwave oven and cartonover onto the top side. The microwave ovenshould be resting in the foam.REMOVING THE MICROWAVEOVEN FROM THE CARTON/REMOVING THE MOUNTING PLATEFINDING THE WALL STUDSBA2PLACEMENT OF THE MOUNTING PLATE1WallStudsCenter3CartonPull the carton up and off the microwave oven.Open the microwave oven door and remove theplastic sheet and tape from inside the microwaveoven door. Remove the tape covering the turntablehub.Foam236Set the microwave oven upright. Remove andproperly discard plastic bags and foam.1The mounting plate is attached to the back of themicrowave oven. Remove the two screws holdingit to the microwave oven. The plate will be usedas the rear wall template and for mounting themicrowave oven to the wall.45