Installation Instructions10STEP 12 CONNECT WATER SUPPLYConnect water supply line to 90° elbow.• Slide compression nut,then ferrule over end ofwater line.• Insert water line into 90°elbow.• Slide ferrule againstelbow and secure withcompression nut.Figure BBFigure CCSTEP 13 CONNECT DRAIN LINEFOLLOW ALL LOCAL CODES AND ORDINANCES.The molded end of the drain hose will fit 5/8" through 1"diameter inlet ports on the air gap, waste tee or disposer.• Determine size of inlet port• Cut drain hose connector on the marked line, if required, to fitthe inlet port.• If a longer drain hose is required, add up to 42" of length fora total of 10' to the factory installed hose. Use 5/8" or 7/8"inside diameter hose and a coupler toconnect the twohose ends.Secure theconnection withhose clamps.Figure DD• Secure the drain hose to the air gap, waste tee or disposerwith clamps.Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FORPROPER DRAIN OPERATION.Waste Tee InstallationFigure EE������� �������Disposer InstallationWaste Tee InstallationFigure FFDisposer InstallationMethod 2 – Drain Hose RoutingRoute the drain hose of the dishwasher to a minimum height of 32" fromthe floor with the supplied hanger as shown.IMPORTANT – When connectingdrain line to disposer, check to be surethat drain plug has been removed.DISHWASHER WILL NOT DRAIN IFPLUG IS LEFT IN PLACE.Tip: Avoid unnecessary service call charges. Always be suredisposer drain plug has been removed before attachingdishwasher drain hose to the disposer.���������������������������������������� ��������������������18"Min.32"Min.05A-1183GGFasten drain hose at least at32" height with hanger suppliedIMPORTANT – Either one of the above methodsmust be used or dishwasher will not operate properly.Method 1 – Air gap with waste tee or disposerInsert the drain hose to air gap as shown.32"Min.18"Min.05A-1183FFFasten drain hose at least at32" height with hanger suppliedIMPORTANT – Check to be sure that door spring doesnot rub or contact the fill hose or water supply line. Test byopening and closing the door. Re-route the lines if a rubbingnoise or interference occurs.DRAIN LINE INSTALLATION• Connect drain line to air gap, waste tee or disposer usingeither previously determined method.9Ferrule90° ElbowCompression NutHot WaterSupply LineCutting Lines1" 3/4" 5/8"IMPORTANT: Do not cut corrugatedportion of hose