GE Spacemaker PDW1800N Install Manual

Also see for PDW1800NBB - Profile 18-in Dishwasher: Owner's manual Energy guide Dimensions and installation information

Contents

GE Spacemaker PDW1800N Install Manual Manual pdf 8 page image

Installation InstructionsSTEP 2 ADJUST LEVELING LEGS• Move the dishwasher close to the installation location and layit on its back.Figure I• Measure installation height and dishwasher height. Extendleveling legs out from the dishwasher base, 1/2" less thaninstallation height.STEP 3 REMOVE TOEKICK• Remove the 4 toekick screws. Lift off the 2 piece toekick.STEP 4 INSTALL POWER CORDSkip this step if dishwasher will be direct wired.Use Power Cord Kit WX09X70910, available for purchasefrom an authorized GE Appliance Dealer. The power cord andconnections must comply with the National Electrical Code,Section 422 and/or local codes and ordinances.• Maximum power cord length is 6'.• Connect incoming power cord white (or ribbed) to dishwasherwhite, black (or smooth) to black and ground to dishwashergreen wire. Use UL listed wire nuts of appropriate size.• Replace junction box cover. Be sure wires are not pinchedunder the cover.Figure KFigure JFigure LSTEP 5 INSTALL 90° ELBOW• Wrap 90° elbow with thread seal tape.• Install a 90° elbow onto the water valve.• Do not over tighten 90° elbow, water valve bracket couldbend or water valve fitting could break.• Position the end of the elbow to face the rear of thedishwasher.6Adjust toInstallationHeightRemove4 ToekickScrewsWhiteGround BlackCheck That White, Black andGreen Dishwasher Wires Are ThreadedThru Hole in BackRemoveJunction BoxCoverInsert PowerCord Wires ThruStrain Reliefand TightenUse UL ListedWire NutsACBD90°ElbowFillHoseThreadSeal TapeWaterValveBracket