GE Multilin L60 Line Phase Comparison System 4-14 HUMAN INTERFACES 4.1 ENERVISTA UR SETUP SOFTWARE INTERFACE44 HUMAN INTERFACES 4.1ENERVISTA UR SETUP SOFTWARE INTERFACE 4.1.1 INTRODUCTIONThe EnerVista UR Setup software provides a graphical user interface (GUI) as one of two human interfaces to a UR device.The alternate human interface is implemented via the device’s faceplate keypad and display (refer to the Faceplate inter-face section in this chapter).The EnerVista UR Setup software provides a single facility to configure, monitor, maintain, and trouble-shoot the operationof relay functions, connected over local or wide area communication networks. It can be used while disconnected (off-line)or connected (on-line) to a UR device. In off-line mode, settings files can be created for eventual downloading to the device.In on-line mode, you can communicate with the device in real-time.The EnerVista UR Setup software, provided with every L60 relay, can be run from any computer supporting Microsoft Win-dows® 95, 98, NT, 2000, ME, and XP. This chapter provides a summary of the basic EnerVista UR Setup software interfacefeatures. The EnerVista UR Setup Help File provides details for getting started and using the EnerVista UR Setup softwareinterface.4.1.2 CREATING A SITE LISTTo start using the EnerVista UR Setup software, a site definition and device definition must first be created. See the EnerV-ista UR Setup Help File or refer to the Connecting EnerVista UR Setup with the L60 section in Chapter 1 for details.4.1.3 ENERVISTA UR SETUP OVERVIEWa) ENGAGING A DEVICEThe EnerVista UR Setup software may be used in on-line mode (relay connected) to directly communicate with the L60relay. Communicating relays are organized and grouped by communication interfaces and into sites. Sites may contain anynumber of relays selected from the UR-series of relays.b) USING SETTINGS FILESThe EnerVista UR Setup software interface supports three ways of handling changes to relay settings:• In off-line mode (relay disconnected) to create or edit relay settings files for later download to communicating relays.• While connected to a communicating relay to directly modify any relay settings via relay data view windows, and thensave the settings to the relay.• You can create/edit settings files and then write them to the relay while the interface is connected to the relay.Settings files are organized on the basis of file names assigned by the user. A settings file contains data pertaining to thefollowing types of relay settings:• Device definition• Product setup• System setup• FlexLogic™• Grouped elements• Control elements• Inputs/outputs• TestingFactory default values are supplied and can be restored after any changes.The following communications settings are not transferred to the L60 with settings files.Modbus Slave AddressModbus IP Port NumberRS485 COM1 Baud RateRS485 COM1 ParityCOM1 Minimum Response Time
