GE WX09X70910 Installation Instructions Manual

Also see for Dishwasher: Use and care guide Owner's manual Installation instructions Use and care guide

Contents

GE WX09X70910 Installation Instructions Manual Manual pdf 6 page image

WhiteGround BlackCheck That White, Black andGreen Dishwasher Wires Are ThreadedThru Hole in BackRemoveJunction BoxCoverInsert PowerCord Wires ThruStrain Reliefand TightenUse UL ListedWire NutsACBDInstallation Instructions6• Do not over tighten 90° elbow, water valve bracketcould bend or water valve fitting could break.• Position the end of the elbow to face the rear of thedishwasher.STEP 5 INSTALL 90° ELBOW• Wrap 90° elbow with thread seal tape. Do not useplumber's putty.• Install a 90° elbow onto the water valve.Figure LFigure JSTEP 3 REMOVE TOEKICK• Remove the 4 toekick screws. Lift off the 2 piecetoekick.• Measure installation height and dishwasher height.Extend leveling legs out from the dishwasher base,1/4" less than installation height.Figure HSTEP 2 ADJUST LEVELING LEGS• Move the dishwasher close to the installation loca-tion and lay it on its back.STEP 4 INSTALL POWER CORDSkip this step if dishwasher will be direct wired. Usepower cord kit WX09X70910 available for purchase froman authorized GE Appliances dealer. The power cord andconnections must comply with the National ElectricalCode, Section 422 and/or local codes and ordinances.• Recommended power cord length is 54" min. and64" max.Figure KAdjust toInstallationHeight• Connect incomingpower cord white (or ribbed)to dishwasher white, black(or smooth) to black and ground to dishwasher greenwire. Use UL listed wire nuts of appropriate size.• Replace junction box cover. Be sure wires are notpinched under the cover.RemoveToekickScrews90ElbowFillHoseThreadSeal TapeWaterValveBracket