CHAPTER 4: INTERFACES FRONT PANEL INTERFACEB30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL 4-174Default values are indicated in this instruction manual in mixed case. In the example shown here, the default access level isRestricted.4.2.4.1 Example4.2.5 Changing settings4.2.5.1 Entering numerical dataEach numerical setting has its own minimum, maximum, and increment value associated with it. These parameters definewhat values are acceptable for a setting.Highest level Lowest level (setting value) SETTINGS PRODUCT SETUP SECURITY ACCESS LEVEL:Restricted SETTINGS SYSTEM SETUP ACTUAL VALUES STATUSPress the MENU key until the header for the first Actual Values page appears. This page containssystem and relay status information. Repeatedly press the MESSAGE keys to display the otheractual value headers. SETTINGS PRODUCT SETUPPress the MENU key until the header for the first page of Settings appears. This page containssettings to configure the relay. SETTINGS SYSTEM SETUPPress the MESSAGE down arrow to move to the next Settings page. This page contains settingsfor System Setup. Repeatedly press the MESSAGE up and down arrows to display the othersetting headers and then back to the first Settings page header. SECURITYFrom the Settings page one header (Product Setup), press the MESSAGE right arrow once todisplay the first sub-header (Security).ACCESS LEVEL:RestrictedPress the MESSAGE right arrow once more and this displays the first setting for Security.Pressing the MESSAGE down arrow repeatedly displays the remaining setting messages for theSecurity sub-header. SECURITYPress the MESSAGE left arrow once to move back to the first sub-header message. DISPLAY PROPERTIESPressing the MESSAGE down arrow displays the second setting sub-header associated with theProduct Setup header.FLASH MESSAGETIME: 10.0 sPress the MESSAGE right arrow once more to display the first setting for Display Properties.FLASH MESSAGETIME: 10.0 sFor example, select the SETTINGS PRODUCT SETUP DISPLAY PROPERTIES FLASHMESSAGE TIME setting.
