4-24 B30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUALFRONT PANEL INTERFACE CHAPTER 4: INTERFACES44.2.8 Custom LED labeling4.2.8.1 Enhanced faceplateThe following procedure requires these pre-requisites:• EnerVista UR Setup software is installed and operational• The B30 settings have been saved to a settings file• The UR front panel label cutout sheet (GE part number 1006-0047) has been downloaded fromhttp://www.gegridsolutions.com/products/support/ur/URLEDenhanced.doc and printed• Small-bladed knifeTo create custom LED labels for the enhanced front panel display:1. Start the EnerVista UR Setup software.2. Select the Front Panel Label Designer item from the Online Window or Offline Window area, for example underSettings > Front Panel Label Designer. If the option does not display, it means that the B30 does not have anenhanced front panel or that no customization is possible. The Online Window has the advantage of displaying thelive fields as opposed to blank fields.The window displays.Figure 4-27: Front panel label designer window3. Enter the text to appear next to each LED and above each user-programmable pushbutton in the fields provided. TheLED Offsets and Button Offsets buttons move all labels left/right and up/down on the page (they both do the sameaction, so use either button). The Button Offsets button does not display when there are no pushbuttons to customize.4. Feed the UR front panel label cutout sheet into a printer and press the Print button in the front panel report window.5. When printing is complete, fold the sheet along the perforated lines and punch out the labels.6. Remove the UR label insert tool from the package and bend the tabs as described in the following procedures. Thesetabs are used for removal of the default and custom LED labels.
