CHAPTER 5: SETTINGS SYSTEM SETUPB30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL 5-13555.5.5 Disconnect switchesSETTINGS SYSTEM SETUP SWITCHES SWITCH 1(24)The disconnect switch element contains the auxiliary logic for status and serves as the interface for opening and closing ofdisconnect switches from SCADA or through the front panel interface. The disconnect switch element can be used tocreate interlocking functionality. For greater security in determination of the switch pole position, both the 89/a and 89/bauxiliary contacts are used with reporting of the discrepancy between them. The number of available disconnect switchesis four per breaker.SWITCH 1 FUNCTION — This setting enables and disables operation of the disconnect switch element.SWITCH 1 NAME — Assign a user-defined name (up to six characters) to the disconnect switch. This name is used in flashmessages related to disconnect switch 1.SWITCH 1 MODE — This setting selects “3-Pole” mode, where disconnect switch poles have a single common auxiliaryswitch, or “1-Pole” mode where each disconnect switch pole has its own auxiliary switch.SWITCH 1 OPEN — This setting selects an operand that creates a programmable signal to operate a contact output to opendisconnect switch 1.SWITCH 1 BLK OPEN — This setting selects an operand that prevents opening of the disconnect switch. This setting can beused for select-before-operate functionality or to block operation from a panel switch or from SCADA. SWITCH 1 SWITCH 1FUNCTION: DisabledRange: Disabled, Enabled SWITCH 1 NAME:SW 1Range: up to six alphanumeric characters SWITCH 1 MODE:3-PoleRange: 3-Pole, 1-Pole SWITCH 1 OPEN:OffRange: FlexLogic operand SWITCH 1 BLK OPEN:OffRange: FlexLogic operand SWITCH 1 CLOSE:OffRange: FlexLogic operand SWITCH 1 BLK CLOSE:OffRange: FlexLogic operand SWTCH 1 ΦA/3P CLSD:OffRange: FlexLogic operand SWTCH 1 ΦA/3P OPND:OffRange: FlexLogic operand SWITCH 1 ΦB CLOSED:OffRange: FlexLogic operand SWITCH 1 ΦB OPENED:OffRange: FlexLogic operand SWITCH 1 ΦC CLOSED:OffRange: FlexLogic operand SWITCH 1 ΦC OPENED:OffRange: FlexLogic operand SWITCH 1 TOPERATE:70 msRange: 0 to 65535 ms in steps of 1 SWITCH 1 ALARMDELAY: 0.000 sRange: 0.000 to 65.535 s in steps of 0.001 SWITCH 1 EVENTS:DisabledRange: Disabled, Enabled
