Gaggenau RC 462 Installation Instruction

Also see for RF 411: Installation instruction Installation instruction Installation instructions Installation instructions Installation instruction

Contents

Gaggenau RC 462 Installation Instruction Manual pdf 24 page image

2412. Adjusting the appliance in the nichem Caution!Never use a power-driven screwdriver for settingthe height of the appliance.Risk of damage to the appliance! Adjust the appliance to the existing furniture.Keep the straight edge on the door, above thepositioning supports.The positioning supports are set out for the followingoverall strengths of the furniture doors to be mounted.– 19 mm– 38 mmRe-examine the actual thickness of the doors to be mountedin order where necessary, to be able to compensate possibledigressions.The height-adjustable feet on the front and rear can allbe adjusted from the front.Front: with a fixed spanner SW 13 mm.Rear: with a 8 mm socket spanner with flexible shaft.There is a mark on the base of the appliance which servesas a standard measurement for setting the height.When setting the height, raise the mark to 32 mm abovethe ground. Screw the height-adjustable screws as far downwardsas possible until the marking on the base has reachedthe given height (32 mm).Note:This dimension is very important for the subsequentadjustment of the cabinet frontage. Adjust the front of the appliance with the spirit level.Note:– Do not tip the appliance in the niche! When screwingdown the height-adjustable feet, proceed stepby step. Lower by alternating left to right.– The rear feet can be set more easily if the applianceis not loaded at the rear.– When using a wooden plank as an alternative anti-tiltmechanism as in point 7. of these mountinginstructions, turn the appliance as far as it willgo against the wooden plank.Do not bend against the wooden plank.