30Important information for furniture doors with cutout(appliances with ice and water dispenser, wine storagecabinets):The cut edges of the door cutout must be protected beforehumidity penetrates. To do this, use the means suitablefor the material and the shape of the furniture door(e.g. edge veneer, edge sealant).Connecting element for furniture doorsInstead of one large door, two furniture doors can bemounted next to each other in the case of applianceswith a width of 76 and 91 cm. These furniture doorsare then connected using a metal strip on the rear.This metal strip is available from your dealer as an instal-lation accessory (Connection element for furniture doors).Further information concerning this can be found in thesection “Tools and accessories which are needed”.When attaching the metal strip to the furniture doors, watchout for the maximum possible length of the screws and theposition of the drill holes. Always carry out screwing jobs onthe most stable part of the furniture door. Never screw intofillings or similar areas.Note:If only one door is to be mounted to an appliance witha width of 76 and 91 cm, attach the supplied sandwichplate to the adjusting rib and fix into position.20. Loading the appliance doorWhen attaching the furniture doors it is recommendedto load the storage sections in the door with weightsin order to ensure that the when adjusting crackdimensions turn out to be as precise as possible.Loading recommendations:Appliance width Loading of the furnituredoor45.1 cm 10 kg60.3 cm 15 kg75.6 cm 20 kg