Gaggia Concetto Operating Instructions Manual

Also see for Concetto: Brochure

Contents

Gaggia Concetto Operating Instructions Manual Manual pdf 35 page image

CONCETTO31/120EnglishF. 910.4 Serial port connectionThrough the serial port the machine can be connected to theAUTHORIZED CUSTOMER SERVICE CENTER’s equipment, forchecks or programming operations (A - F. 9).12 - USE OF THE MACHINERead carefully this brochure until you get a goodunderstanding of the machine, before starting to operateit.After a long time of machine inactivity, read the previousparagraph “First switching-on” before re-operatingthe machine.11 - FIRST SWITCHING-ON- Fill the hopper (6) with the selected coffee beans blend.Be sure the coffee does not contain foreign bodies whichcould be dangerous for grinders.- Check if the removable components (12 and 16) are in theright position and if the door (14) is closed.If they are not, when the machine is switched-on, the displaywill indicate which component is in the wrong position.- Turn the all-pole switch on “I”.- Switch on the machine through the switch (18);the message “WARMING UP” will be displayed.- When the message “READY FOR USE” is displayed :- Adjust the brew group (26 and 27) to obtain the suitableheight depending on the container used (Pr. 8.4).- Place one or two containers under the brew group.- Select the beverage and press the corresponding button.Although buttons are previously programmed on astandard base, check your beverage has the selectedfeatures. If not, they must be reprogrammed (Pr. 12.6).Depending on the current regulations of the Country wherethe machine operates, the cable connecting the electricline has to be pre-set or equipped with an all-pole switch(with a minimum contact opening of 3 mm), (or with aplug in accordance with the same regulations).• The all-pole switch has to be adequate to the machinepower consumption and must be able to intercept everyvoltage polarity.• Check if the electric cables of the system areproportioned to the machine power consumption.The connection point (electric plug or all-pole switch) mustbe located in an easily reachable place, in order todisconnect the machine from the electric line in case ofneed.• Connect the cord (B - F. 6) to the electric network.A