Gaggia Concetto Operating Instructions Manual

Also see for Concetto: Brochure

Contents

Gaggia Concetto Operating Instructions Manual Manual pdf 45 page image

CONCETTO41/120English12.10 Display messagesNOTE - Here follows a list of alarm messages (in addition tothose explained before) that can be displayed and therelative machine conditions.STANDBY: the machine is switched off (the main switch is on “I”)and the automatic switching-on/off functions enabled (Pr. 12.7.1).ANTI-FREEZING: the machine is switched off (the main switchis on “I”) and the function protecting boilers from icing-up is enabled(Pr.12.7.1).PROGRAMMED CLEANING: it is displayed when the machine isperforming the automatic cleaning of the brew group (Pr. 12.7.1).ADD COFFEE: the machine, during the grinding, detects the lackof coffee beans in the relative container (6).FILL CIRCUIT: this message is displayed if the machine detectsthe lack of water in the boilers during a beverage brewing.After checking if there is actually water in the supply network,press the button ( ^ in the COFFEE version), until water comesout properly from the spout (11) and from the brew group (27). Inthe “COFFEE” version the water comes out only from the brewgroupPROGRAMMING: it is displayed during the machine programming(Pr. 12.6).REMOVE GROUNDS: it is displayed if the dump box (16) is almostfull (the machine performed the programmed number of brewings).More brewings can anyway be performed.OUT OF SERVICE – REMOVE GROUNDS: the dump box (16)is completely full (the machine performed the programmed numberof brewings).The machine is blocked and no more brewings can be performeduntil the dump box is emptied.CLOSE DOOR: the door (14) is not properly closed.INSERT BOX: the dump box (16) is not properly inserted.INSERT DRIP TRAY: the drip tray (12) is not properly inserted.INSERT GROUP: the brew group (28) is not properly inserted.GROUP ERROR: the brew group (28) is not properly performinghis working cycle; switch the machine off and call the AUTHORIZEDCUSTOMER SERVICE CENTER.PUMP ERROR: one of the pumps is damaged. Switch the machineoff and call the AUTHORIZED CUSTOMER SERVICE CENTER.SENSOR ERROR 01: is displayed when a temperature sensorfails. Switch the machine off and call the AUTHORIZED CUSTOMERSERVICE CENTER.TEMPER. ERROR 01: is displayed when one of the boilersresistance is damaged. Switch the machine off and call theAUTHORIZED CUSTOMER SERVICE CENTER.DESCALING: it is displayed when the machine needs a descalingintervention, and after performing the programmed number ofbrewings. Switch the machine off and call the AUTHORIZEDCUSTOMER SERVICE CENTER.The descaling interventions are set on working cycles of themachine, and can be programmed by the maintenancet e c h n i c i a n .MAINTENANCE: it is displayed when the machine needsmaintenance and after performing the programmed number ofbrewings. Switch the machine off and refer to the AUTHORIZEDCUSTOMER SERVICE CENTER.The maintenance interventions are set on working cycles of themachine, and can be programmed by the maintenancet e c h n i c i a n .12.11 Machine switching-offProgrammed automatic switching-offThis is possible when the function “AUTOM.SWITCHING-ON”(Pr. 12.7.1) is enabled and the function “TIMES ON/OFF”(Pr. 12.7.1) has been programmed .At the programmed time the machine goes on “STANDBY”.Manual switching-offThis switching-off is necessary if the function “ A U T O M .SWITCHING-ON” (Pr. 12.7.1) is not enabled.It can be obtained by switching both the main switch (18) and theall-pole switch on the “0” position or by disconnecting the plug.