Vers. No. 6.1116 Released: 25/04/20175 Configuration → Configuring analog outputsSince digital signals do not require any Decimal places, youcan enter 0 here. 1 is sufficient for the Field length. With adigital input you can also specify a unit (optional).For several inputs/outputs and the type Status field (Type ofcolumn), as well as the transfer as a number (e.g. as integer),there is also the type Status field 32 with which all existinginputs or outputs are transferred as binary numbers. Define asuitable field length here depending on the number of inputsand outputs.When the dialog is closed, the number of transferred placesand the unit in the column Format/balance are displayed.6. Click in the column Range/error to define the reaction in thecase of an error for the digital outputs (optional).7. Save the changes in a file and close the module once you havemade all the changes: or File > Save to file and finish.The file is created within the project folder and the file nameis generated automatically. The project folder bears the samename as the project. The generated file name contains theaddress of the Test Controller through which the module isconnected and an identifier for the relevant module.IMPORTANTIf the modules are connected through a Test Controller, newmodule settings must also be updated there. Select or File> Write project (update) in the test.commander. The projectfile is in this case automatically updated.5.5 Configuring analog outputsIn order to set parameters you should be connected to the mod-ule and have called the configuration program (ICP 100 which isstarted automatically by test.commander): Mark a module andselect Configuration from the context menu or double click on amodule or module signal (variable) to start the configuration pro-gram. Then carry out all the module settings in the window of thisprogram.You can however also configure a project without a direct con-nection and then, once you have established the connection, loadthe corresponding files into the modules and load Test Controller.All module signals are defined as variables. Therefore, for theentry activate the tab Variable definition in the configurationprogram.
