Part # P143 (11/10/08)Page 6Table F: Pilot Flame LengthMODEL PILOT FLAME LENGTHmm ins.MSTSRC/MSTSR16 25 4 1 0Table G: Australian Nominal Gas Consumption & Injector SizeMODELNatural Gas Propane GasInjector Dia.mmConsumptionMJ/Hr.Gas PressureKPAInjector Dia.mmConsumptionMJ/Hr.Gas PressureKPAMSTSRC 2 4 21 1 1 4 21 2 5DIMENSIONS AND SPECIFICATIONS ContinuedINTRODUCTIONIMPORTANT: The following instructions should be readcarefully before attempting to operate the appliance Themanufacturer cannot be held responsible for any damageto property, persons or animals caused by incorrectinstallation or operation of the applianceYou have purchased the finest commercial cookingequipment available Like any other fine, precision builtpiece of equipment it should be given regular care andmaintenanceIt is required by law that all gas appliances are installed bycompetent persons in accordance with the LOCAL GASSAFETY REGULATIONS Failure to install appliances correctlycan lead to prosecution It is in your own interests and that ofsafety to insure that there is compliance with the lawYour Garland dealer is well qualified to provide this servicePeriodic inspections by your dealer or a qualified servicecompany are recommended to check temperatures, burneradjustments and ensure moving parts are operativeWherever possible avoid overheating idle equipment, as thisis the primary cause for increased service cost“Regular Maintenance Ensures Peak Performance ”UncratingCheck crate for possible damage sustained during transitCarefully remove unit from crate and again check fordamage Any damage to the appliance must be reported tothe carrier immediatelyProduct ApplicationThe Garland infra-red salamander offers broiling for a widevariety of products such as steak, lobster, fish, onion soup,casseroles, garlic bread and hamburgers The over-fire infra-red design provides for quick preheat and efficient, uniformproduction The tilting rack feature allows for an easy viewbroilingOptional Extras• Wall mount accessories.Rating PlateThe data plate is readily accessible, located behind the driptray It contains all of the pertinent information required bythe installerThe type of gas and the supply pressure that the equipmentwas set up for at the factory is noted on the data plate and onthe packaging This type of gas supply must be usedIn the event you have any questions concerning theinstallation, use care or service of this or any other Garlandproduct, write or call our Product Service Department Whencorresponding with the factory or your equipment dealerregarding service problems or replacement parts, be sureto refer to the particular unit by the correct model number(including prefix and suffix letters and numbers) and theserial or code number The rating plate affixed to the unitcontains this information