Garland RTCS GME36-I14C Installation, Operation And Maintenance Manual

Also see for Master Series: Technical reference manual Installation, operating & service manual Brochure Installation and operation manual Installation, operation and maintenance manual

Garland RTCS GME36-I14C Installation, Operation And Maintenance Manual Manual pdf 16 page image

16 Part Number 4533030 Rev 1 07/2017Installation Section 2Function Test• Before Function Tests, read and understandall installation safety instructions regardingPersonal Protection.• Observe also ALL operation safetyrequirements in section 3 Operation.IMPORTANT: AIR MANAGEMENT SYSTEMIncorporated in the Range are internalcooling fans to manage airflow efficiently.These cooling fans are turned onautomatically when:• Any one of the induction hob is ON.• Oven COOK/COOL switch is “I” (ON).• Internal thermostat reads above settemperature.INDUCTION COOK-TOP FUNCTION TESTTesting procedure, for each induction hob:1. Examine the cookware for induction cooking:• Pans must be induction ready. See details insection 3 Operation.• Minimum pan size: Pan must have bottomdiameter larger than 12cm [5”]. Otherwise, thepan will not be heated. This is a safety feature.The sensors do not detect pan smaller than thisminimum size.2. Put some water in an induction pan and place it in thecenter of a cook-zone.3. Turn the control knob to a ON position. The indicatorlamp illuminates and the water is heated.ON PositionAny positionbetweenpower levels“1” to “12”.Indicatorlamp. is on.OFF Position“0” on dial ispointing tothe Indicatorlamp. Thelamp is off.4. The Air System Cooling Fanindicator lamp is ON.5. Remove the pan away from the cook-zone.NOTE: When power transmission to the pan bottomstops, the indicator lamp blinks.6. Place the pan back on the cook-zone. The heatingprocess resumes.NOTE: The indicator lamp illuminates continuouslyagain when energy is being transferred to the pan.7. Turn the control knob to the OFF position. The heatingprocess stops; the indicator lamp goes off.OVEN FUNCTION TESTTest the oven heat and fan functions using different COOK/COOL, Dial, and door settings according to the table below.Oven dial is in the OFF position when oF or oC is pointing tothe dial indicator lamp; the lamp is OFF.COOK/COOLSwitchOven Dial Door OvenHeatElementsOvenFanAirSystemFanO OFF / SetTemp.OPEN /CLOSEOFF OFF ON* /OFF*I OFF OPEN OFF OFF ONI OFF CLOSE OFF ON ONI Set Temp. CLOSE ON ON ONI Set Temp. OPEN OFF OFF ONII OFF / SetTemp.OPEN OFF ON ON* /OFF*II OFF / SetTemp.CLOSE OFF OFF ON* /OFF** Air system fan is ON if internal thermostat reads aboveset temperature; OFF if thermostat reads below settemperature.If the appliance does not function as expected, refer tosection 5 Troubleshooting.