Garland RTCS GME36-I14C Installation, Operation And Maintenance Manual

Also see for Master Series: Technical reference manual Installation, operating & service manual Brochure Installation and operation manual Installation, operation and maintenance manual

Garland RTCS GME36-I14C Installation, Operation And Maintenance Manual Manual pdf 31 page image

Part Number 4533030 Rev 1 07/2017 31Section 5 TroubleshootingAir System TroubleshootingPROBLEM POSSIBLE CAUSE ACTION TO TAKERED indicator lamp ON • Fresh air intake opening is blocked.• The cooling fan(s) has failed.• Internal heat sensor has failed.• Internal temperature is too high.1. IMMEDIATELY, TURN OFF THE OVEN ifit is on.2. Check air filter. Ensure filter is cleanand the air intake opening is notblocked.3. Check ventilation gap (underkickplate) is not blocked.4. Check other indicators of the inductionand oven sections.5. Record details of problem.6. Contact an authorized service agency.Lamp is OFF when:• Any one of theinduction hobs is ON.• Oven COOK/COOLswitch is “I” (ON).• Indicator lamp has failed.• Oven circuit breaker is OFF.1. Check Oven circuit breaker andmain power supply.2. Contact an authorized serviceagency.Convection Oven Troubleshooting* Solutions are listed for reference. For personal safety, any part replacement, adjustment, wiring or calibration must beperformed by authorized service technicians.PROBLEM POSSIBLE CAUSE SOLUTION*Oven too hot or not hot enough. Thermostat out of calibration. Check calibration.Door will not stay closed.Insufficient tension on springs. Adjust tension.Broken spring. Replace part.Broken hinge link. Replace part.Door will not stay open. Too much tension on springs. Adjust tension.Door is not closing on one side. Door warped. Replace part.Door not level or low in center. Trunnion support loose. Level and tighten.Trunnion support worn. Replace part.COOK/COOL switch set to COOK position.Light off. Oven fan is working.No power to oven. Check power supply.Defective COOK/COOL switch. Replace part.Faulty wiring. Check condition of wires and connections.COOK/COOL switch set to COOK position.Light off. Oven fan is not working.Oven door open. Close door.Door switch out of alignment. Align switch.Defective COOK/COOL switch. Replace part.Defective door switch. Replace part.Faulty wiring. Check condition of wires and connections.Defective motor. Replace part.Noisy oven fan motor.Blower wheel rubbing on oven baffle. Adjust blower wheel.Blower wheel loose on motor shaft. Tighten blower wheel.Defective motor. Replace part.COOK/COOL switch set to COOL position.Light on. Oven fan is not working.Door switch out of alignment. Align switch.Defective COOK/COOL switch. Replace part.Defective door switch. Replace part.Faulty wiring. Check condition of wires and connections.