Garland moisture+ Installation And Operation Manual

Garland moisture+ Installation And Operation Manual Manual pdf 15 page image

Part # 1936601 Rev. 6 (01/08) Page 15EXPLANATION OF CONTROLS, (Deluxe Models)Programmable Control, (Deluxe Models)DisplayFive distinct areas of the LED display screen are common tomost programming modes and cooking modes:1. Upper left corner: displays the programmed temperaturefollowed by the word SET.2. Lower left corner: displays actual temperature currentlymonitored by the control, (cavity or probe), followed bythe letters ACT.3. Upper right corner: displays time in hours, minutes andseconds; (00:00:00).4. Lower right corner: displays the word HEAT to indicatewhen the burners or the elements are on and heating.5. Lower center section: displays the operating mode. Whilethe oven is idling, this area is blank. During a cooking cycleit will display COOK. During a hold cycle it will displayHOLD.Refer to the section entitled DISPLAY MESSAGES on page 23for additional information regarding display messages andrelated button sequenced.On/OffPressing this key once switches power modes, (ON or OFF).LightPressing the light key will activate the oven interior light for aperiod of 30 seconds.The light can be programmed to turn on for 30 seconds whenthe door is opened when the oven is in Cool Down or to comeon when the control is counting down.MoistureThis key is used to manually activate the moisture function.It is strongly recommended that moisture only be injectedmanually by holding the button for one second at a time.During a cook cycle that is programmed for moisture, the LEDwill light while moisture is injected into the oven cavity.Moisture can not be manually injected if the fan is running inPulse mode.NOTE: Water can only be injected after the oven haspreheated to at least 225°F (107°C).