Garmin G1000 Cockpit Reference Manual

Also see for Cessna Caravan G1000: Cockpit reference guide Pilot's guide Pilot's guide Pilot's guide Pilot's guide

Contents

Garmin G1000 Cockpit Reference Manual Manual pdf 79 page image

Garmin G1000 Cockpit Reference Guide for the Beechcraft A36/G36 8-7SECTION 8 – FLIGHT PLANNING8.19 TRIP PLANNING1) Turn the large FMS Knob to select the AUX pagegroup.2) Turn the small FMS Knob to select the firstrectangular page icon.3) The current page mode is displayed at thetop of the page: ‘AUTOMATIC’ or ‘MANUAL’.To change the page mode, press the AUTO orMANUAL Softkey.Figure 8-16 Trip Planning Page4) For Direct-to planning, press the WPTS Softkeyand verify that the ‘from’ waypoint field indicatesP.POS (present position). If necessary, pressthe MENU Key and select ‘Set WPT to PresentPosition’ to display P.POS. Press the ENT Key andthe flashing cursor moves to the ‘to’ waypointfield. Turn the FMS Knobs to enter the identifierof the ‘to’ waypoint and press the ENT Key toaccept the waypoint. OR,5) For point-to-point planning, turn the FMS Knobsto enter the identifier of the ‘from’ waypoint.Once the waypoints identifier is entered, pressthe ENT Key to accept the waypoint. Theflashing cursor moves to the ‘to’ waypoint.Again, turn the FMS Knobs to enter the identifierof the ‘to’ waypoint and press the ENT Key toaccept the waypoint. OR,6) For flight plan leg planning, press the FPL Softkey(at the bottom of the display) and turn thesmall FMS Knob to select the desired flight plan(already stored in memory), by number. Turn thelarge FMS Knob to highlight the ‘LEG’ field andturn the small FMS Knob to select the desired legof the flight plan, or select ‘CUM’ to apply tripplanning calculations to the entire flight plan.7) Turn the large FMS Knob to highlight thedeparture time (DEP TIME) field.NOTE: The departure time on the Trip PlanningPage is used for preflight planning. Refer to theUtility Page for the actual flight departure time.8) Turn the FMS Knobs to enter the departure time.Press the ENT Key when finished. (Departuretime may be entered in local or UTC time,depending upon unit settings).9) Turn the FMS Knobs to enter the fuel flow.Press the ENT Key when finished. Note thatin automatic page mode, fuel flow is providedby the system.10) The flashing cursor moves to the fuel on boardfield. Turn the FMS Knobs to modify the fuelon board. Press the ENT Key when finished.Note that in automatic mode this is providedby the system.11) The flashing cursor moves to the calibratedairspeed field. Turn the FMS Knobs to enter acalibrated airspeed. Press the ENT Key whenfinished.