Garmin G1000 Cockpit Reference Manual

Also see for Cessna Caravan G1000: Cockpit reference guide Pilot's guide Pilot's guide Pilot's guide Pilot's guide

Contents

Garmin G1000 Cockpit Reference Manual Manual pdf 122 page image

Garmin G1000 Cockpit Reference Guide for the Diamond DA42NG 190-00963-02 Rev. C106Annunciations & AlertsFlightInstrumentsEISNav/Com/XPDR/AudioAFCSGPS NavFlightPlanningProceduresHazardAvoidanceAdditionalFeaturesAbnormalOperationAnnun/AlertsAppendixIndexGIA 63 MESSAGE ADVISORIES (CONT.)Message CommentsNAV1 SERVICE – NAV1 needs service.Return unit for repair.A failure has been detected in the NAV1and/or NAV2 receiver. The receiver may stillbe available. The G1000 system should beserviced.NAV2 SERVICE – NAV2 needs service.Return unit for repair.NAV1 RMT XFR – NAV1 remotetransfer key is stuck.The remote NAV1 and/or NAV2 transferswitch is stuck in the enabled (or “pressed”)state. Press the transfer switch again to cycleits operation. If the problem persists, theG1000 system should be serviced.NAV2 RMT XFR – NAV2 remotetransfer key is stuck.G/S1 FAIL – G/S1 is inoperative. A failure has been detected in glideslope receiver1 and/or receiver 2. The G1000 system should beserviced.G/S2 FAIL – G/S2 is inoperative.G/S1 SERVICE – G/S1 needs service.Return unit for repair.A failure has been detected in glideslope receiver1 and/or receiver 2. The receiver may still beavailable. The G1000 system should be servicedwhen possible.G/S2 SERVICE – G/S2 needs service.Return unit for repair.GIA 63W MESSAGE ADVISORIESMessage CommentsGIA1 CONFIG – GIA1 config error.Config service req’d. The GIA1 and/or GIA2 configuration settings donot match backup configuration memory. TheG1000 system should be serviced.GIA2 CONFIG – GIA2 config error.Config service req’d.GIA1 CONFIG – GIA1 audio configerror. Config service req’d. The GIA1 and/or GIA2 have an error in the audioconfiguration. The G1000 system should beserviced.GIA2 CONFIG – GIA2 audio configerror. Config service req’d.GIA1 COOLING – GIA1temperature too low. The GIA1 and/or GIA2 temperature is too lowto operate correctly. Allow units to warm up tooperating temperature.GIA2 COOLING – GIA2temperature too low.