Garmin G1000 Cockpit Reference Guide for the Diamond DA42NG 190-00963-02 Rev. C10Nav/Com/XPDR/Audio PanelFlightInstrumentsEISNav/Com/XPDR/AudioAFCSGPS NavFlightPlanningProceduresHazardAvoidanceAdditionalFeaturesAbnormalOperationAnnun/AlertsAppendixIndexENTER A TRANSPONDER CODE1) Press the XPDR Softkey to display the transponder mode selection softkeys.2) Press the CODE Softkey to display the transponder code selection softkeys,for digit entry.3) Press the digit softkeys to enter the code in the code field. When enteringthe code, the next key in sequence must be pressed within 10 seconds, orthe entry is cancelled and restored to the previous code. Five seconds afterthe fourth digit has been entered, the transponder code becomes active.SELECTING A COM RADIOTransmit/ReceivePress the COM1 MIC, COM2 MIC, or COM3 MIC Key (optional COM, ifinstalled) on the audio panel.Receive OnlyPress the COM1, COM2, or COM3 Key (optional COM, if installed) on theaudio panel.SELECTING A NAV RADIO1) To begin navigating using a navigation radio, press the CDI Softkey on thePFD to select VOR1/LOC1 (NAV1) or VOR2/LOC2 (NAV2).2) Press the NAV1, NAV2, DME, or ADF Key on the audio panel to select ordeselect the navigation radio audio source. All radio keys can be selectedindividually or together.NAV/COM TUNING1) Press the small tuning knob to select the desired radio for tuning. A lightblue box highlights the radio frequency to be tuned.2) Turn the respective tuning knobs to enter the desired frequency into thestandby frequency field. The large knob enters MHz and the small knobenters kHz.3) Press the Frequency Transfer Key to place the frequency into the activefrequency field.
