190-00709-00 Rev. A Garmin G1000 Pilot’s Guide for the Socata TBM 850 5-65FLIGHT MANAGEMENTCreating and adding user waypoints to the active flight plan:1) Press the Joystick to activate the panning function on the Active Flight Plan Page and pan to the map locationof the desired user waypoint.2) Select the LD WPT Softkey; or press the MENU Key, select ‘Load Waypoint’, and press the ENT Key. The userwaypoint is created with a name of USRxxx (using the next available in sequence) and is added to the end ofthe active flight plan.ADDING AIRWAYS TO A FLIGHT PLANAirways can be added to the active flight plan or any stored flight plan. Choose a flight plan (add the desiredairway entry point if not already in the flight plan), select the waypoint after the desired airway entry point,select the airway, and it is added in front of the selected waypoint. An airway can only be loaded if there is awaypoint in the flight plan that is part of the desired airway and is not part of an arrival or approach procedure.The G1000 also anticipates the desired airway and exit point based on loaded flight plan waypoints.Figure 5-59 Select Airway Page - Selecting AirwayAirway Entry WaypointSelected AirwayAirways Available at TOPAirway Waypoint SequencePreview ofSelected AirwayAdding an airway to a flight plan:1) Press the FPL Key.2) Press the FMS Knob to activate the cursor (not required on the PFD).3) Turn the large FMS Knob to highlight the waypoint after the desired airway entry point. If this waypoint is nota valid airway entry point, a valid entry point should be entered at this time.
