Garmin G3X Pilot’s Guide190-01115-00 Rev. K249Hazard AvoidanceSystemOverviewFlightInstruments EISCNSInterfaceGPSNavigationFlightPlanningHazardAvoidanceAdditionalFeatures AFCS Annun/Alerts Appendix IndexOPERATIONNOTE: The GTS 800 automatically transitions from STANDBY to OPERATEmode eight seconds after takeoff. The unit also automatically transitionsfrom OPERATE to STANDBY mode 24 seconds after landing.After power-up, the GTS 800 is in Standby Mode. The GTS 800 must be in OperatingMode for traffic to be displayed and for TAs to be issued.Pressing the OPERATE Softkey allows the traffic unit to switch from Standby Modeto Operating Mode as necessary. Pressing the STANDBY Softkey forces the unit intoStandby Mode.Switching from operating mode to standby mode:On the Traffic Page, select the STANDBY SoftkeySwitching from standby mode to operating mode:On the Traffic Page, press the OPERATE SoftkeyChanging the altitude range:1) On the Traffic Page, select the ALT MODE Softkey.2) Press one of the following Softkeys:• ABOVE: Displays non-threat and proximity traffic from 9000 feetabove the aircraft to 2700 feet below the aircraft. Typically used duringclimb phase of flight.• NORMAL: Displays non-threat and proximity traffic from 2700 feetabove the aircraft to 2700 feet below the aircraft. Typically used duringenroute phase of flight.• BELOW: Displays non-threat and proximity traffic from 2700 feetabove the aircraft to 9000 feet below the aircraft. Typically used duringdescent phase of flight.• UNREST (unrestricted): All traffic is displayed from 9900 feet aboveand 9900 feet below the aircraft.3) To return to the Traffic Page, press the BACK Softkey.
