3-35190-00601-02 Rev. J Garmin G500/G600 Pilot’s GuideCoverTOCForewordSec 1SystemSec 2PFDSec 3MFDSec 4HazardAvoidanceSec 5AdditionalFeaturesSec 6Annun.& AlertsSec 7SymbolsSec 8Glossary Appendix A IndexFigure 3-46 Date and Time Values4. A Time Offset may be entered by using the large and small MFD knobs tochange the values. Press ENT after completing any changes.5. Press the small MFD knob to exit adjustments.3.2.1.8 MFD Display UnitsThe MFD Display Units options allow you to select the units of measurementconventions displayed on the MFD. Distance and Speed selections are Imperial,Metric, or Nautical. Altitude and Vertical speed selections are Feet or Meters.Traffic information is always shown in Nautical Miles (distance) and Feet(altitude).1. While viewing the System Setup page of the AUX page group, press the smallMFD knob to activate the cursor. Turn the large MFD knob to highlight theDistance and Speed (DIS, SPD) units of measurement.Figure 3-47 Distance and Speed MFD Display Units2. Turn the small MFD knob to select Imperial, Metric, or Nautical and then pressENT. The Altitude and Vertical Speed units selection will now be highlighted.3. Turn the small MFD knob to select Feet or Meters and then press ENT.
