4-82Garmin G500/G600 Pilot’s Guide 190-00601-02 Rev. JCover TOCForewordSec 1SystemSec 2PFDSec 3MFDSec 4HazardAvoidanceSec 5AdditionalFeaturesSec 6Annun.& AlertsSec 7SymbolsSec 8GlossaryAppendix AIndex4.7.20 XM Cell MovementCell Movement data shows the location and movement of storm cells asidentified by a ground-based system. Cells are represented by yellow squares,with direction of movement indicated with short, orange arrows.Figure 4-61 XM Weather - Cell MovementOn most applicable maps, Cell Movement data is selected for display alongwith NEXRAD. On the Weather Data Link Page, Cell Movement data can beselected independently.Cell Movement Data Viewing RangeThe Cell Movement Data Viewing Range option allows you to select the maprange and below where Cell Movement weather products will appear on theselected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected, CellMovement will not be shown. Where a value (such as 100 NM) is selected, CellMovement data will be shown at map ranges of the selected value (100 NM)and lower.1. While viewing Weather Setup 2/2 menu, turn the large MFD knob to highlightthe Cell Movement Data Viewing Range option.2. Turn the small MFD knob to highlight the desired value. Press ENT to acceptthe displayed value. The next option will be highlighted.3. Press the small MFD knob to cancel selection or to end editing and return tothe previously viewed page or turn the large MFD knob to the next option.
