Garmin GDL 90 Installation Manual

Also see for GDL 90: Installation manual

General InformationGDL 90 Installation Manual 560-1049-00 Rev B 1-11 GENERAL INFORMATION1.1 ABOUT THIS MANUALThis manual describes the installation and checkout procedures for the GDL 90 UAT Data Link Sensor.It is intended for use by persons certified by the Federal Aviation Administration (FAA) to installavionics devices.1.1.1 MANUAL ORGANIZATIONProvides GENERAL INFORMATION about the GDL 90 unit. TSO certificationinformation is also included in this section.Includes INSTALLATION PROCEDURES.Includes LIMITATIONS for the equipment and installation.Includes POST-INSTALLATION CONFIGURATION AND CHECKOUT.Includes TROUBLESHOOTING information.Includes PERIODIC MAINTENANCE requirements.Includes CERTIFICATION DATA.Includes TROUBLESHOOTING FLOWCHARTS.Includes INTERCONNECT DIAGRAMS.Includes CONSTRUCTION & VALIDATION of structures.1.1.2 SCOPEThe information in this manual is STC approved. Only the equipment interfaces covered in this manualare within the scope of this STC. Other equipment may be suitable for use with the GDL 90, but use ofsuch equipment is beyond the scope of this STC – additional FAA approval may be required if equipmentnot covered in this manual is used to interface to the GDL 90.Antenna installation in the pressure vessel of pressurized aircraft is also beyond the scope of the GDL 90STC. Additional manufacturer's data may be necessary and FAA approval may be required to cover theinstallation of the antenna.Refer to Section 3 Limitations for additional information.SECTION 1SECTION 2SECTION 3SECTION 4SECTION 5SECTION 6APPENDIX AAPPENDIX BAPPENDIX CAPPENDIX D