Garmin PERSONAL NAVIGATOR GPS 95 XL Owner's Manual

Contents

8-15To select GARMIN input/output...· Place the cursor on the input/output format field.· Press CLR until the GARMIN input/output option is selected.· Press the right arrow key.· Select “HOST”, “REQUEST”, or “SEND” by pressing CLR. (NOTE:You should select the “HOST” option when using the GPS 95 with aPC. When exchanging data between two GPS 95s, one should be setto “HOST” and the second should be set to the desired data transferoption - “REQUEST” or “SEND”.)The GPS 95 can use Differential GPS(DGPS) corrections in RTCM SC-104version 2.0 format. DGPS correctionsin this format can be received from anexternal device (capable of output in 6to 8 byte format as specified by RTCMSC-104 version 2.0) by connecting thedevice to the input port on the back ofthe GPS 95 and selecting an RTCM input interface mode. Two RTCM inputmodes are available; one which allows no output and another which allowsNMEA output in 0180, 0182, or 0183 format.To select an RTCM input...· Place the cursor on the input format field.· Press CLR until the desired RTCM input option (RTCM/NONE orRTCM/NMEA) is displayed.· Press the right arrow key.· If RTCM/NONE is selected: Press CLR to select the appropriate baudrate.· If RTCM/NMEA is selected: Press CLR to select the desired NMEAoutput format. (NOTE: With RTCM/NMEA selected the RTCM baudrate is automatically set to 1200 or 4800.)If the RTCM input is selected, but the GPS 95 is not connected to an RTCMdevice, the unit will alert you with the message “No RTCM Input”. If the GPS95 does not receive sufficient data to compute a DGPS-corrected position,the message “No DGPS Position” will appear.