6 Quest Owner’s ManualU NIT OVERVIEW > VEHICLE INSTALLATIONTo mount the extending vehicle suction mount:1. Loosen the two adjustment knobs on the right side of themount and extend the mount assembly as shown. Retightenthe knobs to keep the mount in place.2. To ensure a tight grip, clean and dry your windshield andthe inside of the suction cup.3. Flip the suction lever on the suction cup toward you.4. Place the suction mount in the selected location on yourwindshield.5. Push the suction lever toward the windshield to tightenthe suction cup to the glass. Apply gentle pressure to thesuction mount to make certain the grip is secure.Suction lever pushed downtoward the windshieldMount AdjustmentknobsSuction cupTo position the mount for maximum viewing, loosen theadjustment knobs and position the bracket. Tighten the adjustmentknobs when you are done. You can also adjust the bracket’shorizontal angle by twisting the mount left or right.To remove the suction cup from the windshield, flip the suctionlever toward you to release the suction cup’s grip. To help releasethe grip, pull the rubber tab on the suction cup toward you.Connecting the Vehicle Adapter to Your VehicleThe Quest’s suction mount vehicle adapter includes a 12/24-VoltDC adapter with an external speaker system. Plug the cigarettelighter portion of the vehicle adapter into an available receptacle inyour vehicle. Make sure the cable does not interfere with vehicleoperation in any way.Increase or decrease the volume by adjusting the volume controlknob on the side of the speaker.Using the Mounting DiskCalifornia drivers, use the enclosed mounting disk as an alternativeto using the suction cup mount on your windshield. See page 52 formore information