Garmin Quest TM Owner's Manual

Also see for Quest: Owner's manual Features Declaration of conformity Owner's manual

Contents

Garmin Quest TM Owner's Manual Manual pdf 60 page image

52 Quest Owner’s ManualAPPENDIX > C HANGING THE FUSE AND INSTALLING THE MOUNTING DISKChanging the FuseThe tip of the suction mount contains an AGC/3AG 1 Amp, high-breaking capacity, 1500 A rated fuse. Periodically, you may needto change it. Unscrew and remove the black, round end piece.Remove the metal tip and then remove and replace the fuse.FuseInstalling the Mounting DiskSelect a suitable location on your dashboard to place the mountingdisk. Be sure to select a location where the unit has an unobstructedview of the sky and does not interfere with the driver’s view of theroad or obstruct any controls in the vehicle.WARNING: The mounting disk affixes to your dashboard withpermanent adhesive that is extremely difficult to remove after it isinstalled.To mount the disk:1. Clean and dry the area on your dashboard where you wantto place the mounting disk.2. Remove the backing from the permanent mountingadhesive on the bottom of the disk and place the disk on thedashboard. Press firmly for several seconds.3. Make sure the suction lever located on the suction cup ispulled up (away from the disk). Place the unit’s suction cupmount on top of the disk.4. Flip the suction lever down toward the disk to securethe suction cup mount to the disk. Adjust the mount asnecessary.Suction Cup Mount on the Mounting DiskMounting disk