Gastroback 42526 Design Multicook Plus Operating Instructions Manual

Gastroback 42526 Design Multicook Plus Operating Instructions Manual Manual pdf 12 page image

54If necessary, this function can be switched off by pressing and holding the ›Start / Keep Warmon / off‹-button. The corresponding indicator will switch off. This function can also be turnedon or off during operation at any time.warm-up FunctionWith the Design Multicook Plus you can also reheat cold food.1. Place the food in the inner pot and insert it into the appliance.2. Close the lid, and connect the appliance to the power outlet.3. Press and hold the ›Cancel / Keep Warm‹-button for a few seconds. Keep Warm indicatoron the display and the LED button will be light on. The time indicator will start shows theelapsed heating time.The appliance heats the dish to 70 - 80 °C and will keep it in tis state for 24 hours. This func-tion can also be turned on or off during operation at any time by pressing and holding the›Start / Keep Warm on / off‹-button. The corresponding indicator will switch off.Although the appliance can keep the food in a heated state up to 24 hours, it is not recom-mended to warm up your dish for more than two or three hours, as this can lead to a changein taste and consistency.program MulticookThis program is suitable for almost any kind of food, because you can adjust the temperatureand cooking time required. The setting range of the temperature is 35 °C - 180 °C in steps of5 °C. The setting range of the time is 2 minutes to 15 hours in 1-minute steps (for the range upto 1 hour) or 5 minutes steps (for a time interval of more than 1 hour).note: The appliance does not switch to keep warm mode when the cooking temperature isselected below 75 °C. When the cooking temperature is more than 140 °C, the cooking timemay not exceed 2 hours.The 24-hour Auto-Start-Function is available for this program.1. Prepare the ingredients according to the recipe. Place these evenly in the inner pot andinsert the inner pot into the housing. Please make sure that all ingredients, including liquids,are below the maximum mark (10 Cup) on the inner surface of the inner pot. Make sure thatthe inner pot is firmly in contact with the heating element.2. Close the lid until it clicks into place. Connect the appliance to the power outlet.3. Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to selectthe program ›Multicook‹. Once ›Multicook‹ flashes on theLED-display the program is selected. The LED-display showsthe default values for the temperature and cooking time. (Thepre-set cooking time is 30 minutes, the pre-set cooking tempe-rature is 100 °C.)4. Use the ›Timer / t °C‹-button to reach the time selection mode. The minute indicator flashes.Use the › + ‹ and › – ‹-buttons to adjust the time. With the ›Hour / Min‹-button you can switchbetween hours and minutes. The LED-display shows the pre-set cooking time 30 min. You canadjust the cooking time from 2 minutes to 15 hours.