Gastroback 42526 Design Multicook Plus Operating Instructions Manual

Gastroback 42526 Design Multicook Plus Operating Instructions Manual Manual pdf 25 page image

5. If necessary, adjust the Auto-Start-Function to start cooking later.6. Press and hold for a few seconds the ›Start / Keep Warm on / off‹-button to start the appli-ance. The ›Start / Keep Warm on / off‹-button lights up and the countdown of the cooking timeis shown in the time indicator.7. The Keep-Warm-Function turns on automatically, immediately after the program is over. Ifnecessary, this function can be switched off by pressing and holding the ›Start / Keep Warmon / off‹-button at any time.8. After completion of the program an acoustic signal will sound. Depending on the settings ofthe appliance, the Keep-Warm-Function will launch (the LED-display counts up the time) or theappliance will return to standby mode.9. To cancel the selected program, to interrupt the cooking process or the Keep-Warm-Functionpress and hold the ›Cancel / Keep Warm‹-button for a few seconds.You can use a wooden skewer or toothpick to check the doneness of your cake. If there is nodough sticking to the toothpick after inserting into the cake, your cake is ready.During preparation of bread, disable the ›Keep Warm‹-Function at all stages of the cookingprocess.program pilafThe program is recommended for the preparation of various types of pilaf (long cooked stew withrice, meat and carrots). The setting range of the time is 10 minutes to 2 hours in 5-minute steps. The24-hour Auto-Start-Function is available for this program.1. Prepare the ingredients according to the recipe. Place these evenly in the inner pot andinsert the inner pot into the housing. Please make sure that all ingredients, including liquids,are below the maximum mark (10 Cup) on the inner surface of the inner pot. Make sure thatthe inner pot is firmly in contact with the heating element.2. Close the lid until it clicks into place. Connect the applianceto the power outlet.3. Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to selectthe program ›Pilaf‹. Once ›Pilaf‹ flashes on the LED-display theprogram is selected. The LED-display shows the default valuesfor the temperature and cooking time.4. Use the ›Timer / t °C‹-button to reach the time selection mode. The minute indicator flashes.Use the › + ‹ and › – ‹-buttons to adjust the time. With the ›Hour / Min‹-button you can switchbetween hours and minutes. The LED-display shows the preset cooking time 1 hour. You canadjust the cooking time from 10 minutes to 2 hours.5. If necessary, adjust the Auto-Start-Function to start cooking later.6. Press and hold for a few seconds the ›Start / Keep Warm on / off‹-button to start the appli-ance. The ›Start / Keep Warm on / off‹-button lights up and the countdown of the cooking timeis shown in the time indicator.7. The Keep-Warm-Function turns on automatically, immediately after the program is over. Ifnecessary, this function can be switched off by pressing and holding the ›Start / Keep Warmon / off‹-button at any time.67