Genie GCL-J&H 1/2HP Installation Manual

6.5Setting Limit Overrunwww.geniecompany.com 04-14A) The Limit Overrun setting is a matter of trial and error. The goal is to adjust the LimitOverrun until an appropriate seal is obtained between the bottom edge of the doorand the floor.B) The Limit Overrun setting can be varied between 0 and 9. 0 - disables the LimitOverrun so that the door stops at the down limit switch setting. 9 - causes the greatestamount of door travel beyond the limit switch setting. Door should close gently withlight tension on door cables,or minimal stacking on rolling steel slats.1) Press CAL-RUN to enter calibration mode2) Press scroll (DN) until the display reads “LIMIT OVERRUN>(0-9).” Fig. 9.3) Press SET/CLEAR until the display reads the desired value.4) Press the OPEN key to open the door a few feet,then release5) Press the CLOSE key to close the door and hold until the operator stops.6) Check the door seal and repeat steps 3-5 until the appropriateseal is obtained between the door and the floor.7) Press CAL-RUN to return to Run mode.WARNING: The Limit Overrun will override externalreversing devices, including photocells and sensing edges orreversing edges. Therefore, any externally connected devices willbe disabled during that portion of the door travel controlled by theLimit Overrun function.The Down Limit Overrun function should be used to close the doorno more than the final 2”.AVERTISSEMENT: La fonction dedépassement de limite annulera les dispositifs de renversementexternes, y compris les cellules photoélectriques et des systèmesde détection ou d'inversion aux bords. En conséquence, tous lesdispositifs externes connectés seront désactivés pendant la partiede la course de la porte qui est contrôlée par la fonction dedépassement de limite.La fonction de dépassement de limite inférieure doit être utiliséepour fermer la porte uniquement aux derniers 5 cm.CAUTION: If proper seal cannot be obtained at asetting of 9, Reset the Limit Overrun back to 0 and reset theDown Limit position as described on 6.4. Then adjust the LimitOverrun as instructed above.ATTENTION: Si une adhésion appropriéene peut être obtenue à un réglage de 9, réinitialiser ledépassement de limite à 0 puis la position de déplacement dela limite inférieure selon les instructions de la page 6.4. Réglerensuite le dépassement de limite tel qu'indiqué ci-dessus.OPENCLOSESTOPCALRUN SCROLLSCROLLSETCLEARLIMIT OVERRUN #Figure 9