Genie GCL-J&H 1/2HP Installation Manual

OPENCLOSESTOPCALRUN SCROLLSCROLLSETCLEARODC STB ONFigure 16Monitored Reversing DevicesSafe-T-Beams® (OPTIONAL)1) If operator is in RUN mode, press CAL/RUN key to enter calibration mode.2) Press SCROLL key (up or down) until display reads “ ODC STB>ON” or“ ODC STB>OFF” Figure 16.3) Press SET/CLEAR key to toggle between ON and OFF.4) Press SCROLL key (up or down) to shift to a new function and lock setting.5) Press CAL/RUN key to return to run mode.O NL ECALRUNC LLSSETCLEARSCROLLLOSESTOPCALRUNSC OLLCLE RSCROLLLEA6.10NOTE: Installation of photocells or residential MonitoredPhotocells DOES NOT make the unit legal for residential use. The Genie®Company strictly prohibits any installation of a unit in anyresidentially zoned construction.www.geniecompany.com 04-14Current UL Approved Monitored Reversing Deviceswith Timer-Close Module P/N OPABTCGX.S.2) MillerEdge ME and MT series monitored edge sensors used in combinationwith MillerEdge Interface Module OPAKMEIGX.S. (Direct connect through STB inputs).4) Residential Safe-T-Beam® Monitored Photocells - P/N 37220R (GSTB-BX) and 38176R.S (includes extension brackets)5) Series II Commercial Safe-T-Beam® Monitored Photocells - P/N OPAKPE.S and OPAKPEN4GX.S (NEMA 4).1) MillerEdge ME and MT series monitored edge sensors used in combination6) Monitored Retro-Reflective Photoeye - P/N OPGAKRPEN4X.S3) MillerEdge Wireless monitored edge sensor OPAKMMWE.S.WARNING: Photocell systems provide entrapment protectionwhen mounted near the doorway in such a way that the lower portion of anindividuals leg will break the photocell beam during normal walking throughthe doorway.AVERTISSEMENT: Les systèmes de cellulesphotoélectriques fournissent une protection contre le coincement s'ils sontinstallés à proximité de la porte de manière à ce que la partie inférieure de lajambe d'un individu puisse rompre le faisceau de la cellule photoélectriquelors de passages normaux par la porte.