Genie GCL-J&H Installation Manual

Genie GCL-J&H Installation Manual Manual pdf 31 page image

6.8CLOSESTOPCAL SETLEARN NEW XMTR?Adding a Transmitter1) If operator is in RUN mode, press CAL/RUN key to enter calibration mode.2) Press SCROLL key (up or down) until display reads “LEARN NEW XMTR? ”Figure 13.This question along with the instruction “HIT SET FOR YES” willcontinuously pan across the display window. (Pressing SCROLL orCAL/RUN will cancel the operation.)3) Press SET/CLEAR key.Display will read “PUSH XMTR BUTTON TWO TIMES TO LEARN XMTR.”4) Press Transmitter button two times.The display will read “XMTR ___LEARNED.” Where it assigns a randomnumber between 1 and 50 to the transmitter. That transmitter isentered and ready to operate the door. (Label/mark the transmitter.)5) Press SCROLL key (up or down) to move on to another menu item,or CAL/RUN key to exit the CAL mode.(Optional) Transmitter ProgrammingLOCALRUNCSCROLCSECL ARSETCLEARSCROLLCALRUNRemoving Individual Transmitter1) If operator is in RUN mode, press CAL/RUN key to enter calibration mode.2) Press SCROLL key (up or down) until display reads “REMOVE XMTR? ”Figure 14This question along with the instruction “HIT SET FOR YES” willcontinuously pan across the display window. (Pressing SCROLL orCAL/RUN will cancel the operation.)A menu displaying the available transmitter numbers will appear.Press SCROLL key (up or down) to cycle through the menu to thenumber of the transmitter to be removed. (Pressing CAL/RUN willcancel the operation.)The transmitter is removed.5) Press SCROLL key (up or down) to move on to another menu item,or CAL/RUN key to exit the CAL mode.L ECALRUNC LSCROLLSCROLLCALRUNCLOSESTOPCAL SETREMOVE XMTR?Figure 14Removing All Transmitters1) If operator is in RUN mode, press CAL/RUN key to enter calibration mode.2) Press SCROLL key (up or down) until display reads “REMOVE ALL XMTRS”Figure 15.This question along with the instruction “HIT SET FOR YES” willcontinuously pan across the display window. (Pressing SCROLL orCAL/RUN will cancel the operation.)3) Press the SET/CLEAR key.The display will read “ARE YOU SURE.”All transmitters are removed.5) Press SCROLL key (up or down) to move on to another menu item,or CAL/RUN key to exit the cal mode.CALRUNCROLLS O LSETCLEAR4) Press the SET/CLEAR key.SETCLEARSCROLLCALRUNCLOSESTOPCAL SETREMOVE ALL XMTRS?Figure 15SCROLL3) Press SET/CLEAR key.SETCLEAR4) Press SET/CLEAR key.SETCLEAFigure 13www.geniecompany.com 0-12Standard Duty OperatorGCL-J&H