Genie GCL-T Installation Manual

Also see for GCL-T: Specifications Product guide

4.4www.geniecompany.com 06-126) Uncoil the drawbar chain and install by routing the chain over the chainguides (A) and around the drive sprocket (B) on the output shaft as shownin Fig. 6.7) Attach to Chain Tension Adjusting Bolt (C) using a master link (provided).8) Pass the other end of the chain between the front spreader bracket andthe idler pulley (D). Make certain the chain is not twisted.9) Attach the chain to the carriage (E) using a master link.10) Insert the Adjusting Bolt through the hole in the Carriage and place thetensioning spring, flat washer and adjusting nut onto the bolt. Detail A,Fig 6.11) Tighten Chain so that it will not jump a sprockets or pulley. Add locknut.Check to ensure the following:• The chain is properly engaging the output sprocket.• The chain is not twisted.WARNING• DO NOT apply line voltage until instructed to do so.• Repairs and adjustments, including particularly to cables and springassemblies under high tension, must be made by a trained servicerepresentative using proper tools and instructions.Drawbar Assembly (continued)Detail ACHAINTENSIONADJUSTMENTSCREWFLAT WASHERLOCKNUTADJUSTING NUTTENSIONINGSPRINGMASTERLINKMASTERLINKFigure 6A ACDEBStandard Duty OperatorGCL-T