Genie GPS-IC Owner's Manual

Also see for GPS-IC Series: Owner's manual Owner's manual

Contents

Genie GPS-IC Owner's Manual Manual pdf 21 page image

1. Disconnect the power cord from the branchcircuit mains.2. Remove bottom cover from power head.• Remove four (4) hex head screws from frontand rear covers.• Slide bottom cover off.3. Remove existing power cord from power head.• Disconnect three power cord wires.• Remove and discard power cord.• Remove 7/8” diameter knock-out plug.• Install a suitable entrance bushing.4. Install permanent wiring to power head.For Stealth—connect permanent wiring tointernal terminal block.• Connect white supply line to silver terminal.• Connect black supply line to brass terminal.• Connect ground wire to green wire location(GROUND).For ProMax—connect permanent wiring.• Make connections with UL recognized wire nuts.• Connect white supply line to white wire.• Connect black supply line to black wire.• Connect ground wire to green wire location(GROUND).• Wires inside operator are to be a minimum of6 inches.5. Replace power head bottom cover.• Replace and tighten four (4) hex head screws.NOTE: Circuit boards are light sensitive. Make surecover is on power head before operation.1. Check local building codes.• Some building codes require direct wiring to abranch circuit. If direct wiring is NOT required,plug door operator into grounded outlet(Fig. 6-1).2. Return to Section 3 for SAFE-T-BEAM® Systemalignment and troubleshooting.NOTE: If permanent wiring is required, have aprofessional electrician install circuit and wiredoor operator.Fig. 5-1Operatorpower cordGroundedoutletTo reduce the risk of electrical shock, this equipmenthas a grounding type plug that has a third(grounding) pin. This plug will only fit into a groundingtype outlet. If the plug does not fit into the outlet,contact a qualified electrician to install the properoutlet. Do Not change the plug in any way. The dooroperator must be properly grounded to preventpersonal injury and damage to the components.The ELECTRICAL POWER to the door operatorMUST BE TURNED OFF when power head cover isremoved. Electrical power must remain off whilemaking electrical connections.5 ... CONNECT OPERATOR TO POWER FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM21PERMANENT WIRING INSTRUCTIONS FOR ELECTRICIANWARNING