Genie GPS-IC Owner's Manual

Also see for GPS-IC Series: Owner's manual Owner's manual

Contents

Genie GPS-IC Owner's Manual Manual pdf 26 page image

1. Install light bulb(s) into socket(s).Do Not use short neck bulb(s).• Use bulb(s) rated for:– rough service.– vibration.– appliances.• 100 watt maximum.2. Bend two (2) slotted tabs up. This will activatethe ”living hinge” of the lens (Fig. 11-1).NOTE: The following steps use the screws from theBlue Parts Bag that were set aside earlier.3. Start two (2) No. 8 x 3/4” hex head screws intobottom holes of panel (Fig. 11-2).• Slide slotted tabs up behind hex head screws.• Tighten hex head screws.4. Align lens holes and holes of panel.• Insert and tighten a No. 8 x 5/8” pan headscrew into each round lens hole and tighten,NOTE: Screw heads fit completely into recess oflens tab.Fig. 11-2Fig. 11-1Pan headscrewsBend tabs upSlotted tabsBend tabs up (2)Hex headscrews11 ... LIGHT BULB AND LENS INSTALLATION FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM26[10][10][9]Hex Head ScrewNo. 8 x 3/4”Pan HeadPhillips ScrewNo. 8 x 5/8”[9]