Genie GPS-IC Owner's Manual

Also see for GPS-IC Series: Owner's manual Owner's manual

Contents

Genie GPS-IC Owner's Manual Manual pdf 25 page image

1. Turn remote control upside down (Fig. 10-1)2. Battery replacement (your remote control isbattery powered).• Gently push straight IN on tab as shown(Fig. 10-1).– use ball point pen, coin or small screwdriver.– battery cover snaps open.• Install new battery in same position.– use A23, 12 Volt battery.3. Attach visor clip to remote control (Fig. 10-2)• Slide visor clip into back of case until it snapsinto place.4. Remote control operation• Point remote control at the garage door andpress the button. Door will move.• Press remote control button again and doorwill stop.• Press remote control button again and the doorwill move the other way. The door automaticallystops at the end of the open or close cycle.Fig. 10-1Fig. 10-2Visor clipBatteryBatterycover+–Fig. 9-1LearncodebuttonRadiosignalindicatorMORE MORELIMIT ADJUSTMENTCLOSE OPENPUSHLIMITSTO SET4321CLASS 2NECNECCLASS 2123456MOREFORCEPUSHBUTTONSAFETYBEAMLIMITSETOPENFORCECLOSEFORCERADIOSIGNALLEARNCODECOMDO NOTPUSHLIMIT SETUNLESSDOOR ISATTACHEDNOTE:USE ONLY WITHSERIES II CONTROLSCLOSEMORE OPENMORECLOSE OPENLIMIT ADJUSTMENTU.S. Patent No. 5,243,7845,221,869STEALTHPRO-MAX• Press and release a remote control button.– LED on power head stops blinking.• Press and release same remote button again.– LED goes out. Remote is now programmed.2. Program multi-button remote control• Repeat step 1 (“program one-button remote” foreach button).NOTE: Each button on a multi-button remote controlis for a different operator.3. Operate remote control• Point remote control at door– Door moves• Press button again– Door stops• Press button again– Door reversesNOTE: Door automatically stops at end of open orclose cycle.4. Erasing all receiver memory• Press and hold learn code button onpower head– 10 seconds or until light goes out– Memory is erased• Program door operator again• Press remote control button once within30 seconds– LED on power head stays lit• Press remote control button again– LED on power head goes out and remotecontrol is programmedNOTE: If LED blinks approximately 4 times persecond, programming has stopped. If programmingstops, repeat above steps.RadiosignalindicatorLearncodebutton 2510 ... BATTERY / VISOR CLIP INSTALLATION