Section 3 • Scheduled Maintenance ProceduresREV BNovember 2008Part No. 112657 GS-2668 RT • GS-3268 RT 3 - 29Checklist D ProceduresD-1Check the Scissor Arm WearPadsGenie requires that this procedure be performedevery 1000 hours or annually, whichever comesfirst.Maintaining the scissor arm wear pads in goodcondition is essential to safe machine operation.Continued use of worn out wear pads may result incomponent damage and unsafe operatingconditions.1 Measure the thickness of each chassis wearpad at the steer end of the machine.Result: The measurement is 5/ 16 inch / 8 mm ormore. Proceed to step 2.Result: The measurement is less than5 /16 inch / 8 mm. Replace both wear pads.2 Measure the thickness of each chassis wearpad at the non-steer end of the machine.Result: The measurement is 5/ 16 inch / 8 mm ormore. Proceed to step 3.Result: The measurement is less than5 /16 inch / 8 mm. Replace both wear pads.3 Measure the thickness of each platform scissorarm wear pad at the steer end of the machine.Result: The measurement is 5/ 16 inch / 8 mm ormore. Proceed to step 4.Result: The measurement is less than5 /16 inch / 8 mm. Replace both wear pads.4 Measure the thickness of each platform scissorarm wear pad at the non-steer end of themachine.Result: The measurement is 5/ 16 inch / 8 mm ormore.Result: The measurement is less than5 /16 inch / 8 mm. Replace both wear pads.
