7a. Secure emergency release handle tocord (L) and attach emergency releasecord to shuttle in rail (J).7b. Using the emergency release cord,disengage the shuttle/carriage.7c. Sectional Doors typically acceptcurved door arm (D). In some cases,straight door arm (F) may be used ifthe door bracket is mounted on thetop edge of door.7d. With the door closed, the angle from doorarm (D) to header is 30˚ max.Note: One-Piece Door (Top Edge/Face Mount)instructions are in the Operation and Maintenance Manual provided.7 Attaching Door Arm to DoorBracket and Shuttle (BLUE BAG hardware)LJ7aJFDDDF7c 7c (alt)7c (alt) 7dDDoor bracketClevis pinClevis pinClevis pinCotter pinorCotter pinDoorHeader3/8"-16 x 7/8"Bolt &3/8" Lock nutDoor end rail sectionCotter pin30° maxDoor bracketRelease handleOrange BagSectional Door (Typical):6a. Center bracket on door, higher than thetop set of door roller s.6b. Using bracket, mark holes on door orframe.6c. Drill 1/8" holes.6d. Secure with 1/4"–20 x 3/4"self-drilling screws.6e. .Some garage door manufacturersprovide door brackets that CAN beused with your Genie Door Arms.Sectional Door (Wooden):6a. Center bracket on door, higher than the top set of door rollers.6b. Using bracket, mark holes on door frame.6c. Drill 1/8" holes completely through door.6d. Fasten bracket with 5/16" x 2" carriage bolts and nuts (not furnished).6 Attaching Door Bracket to Door(ORANGE BAG hardware)Doors made of masonite, lightweight wood, berglass, and sheet metal must be properlybraced before mounting door opener. Contact door manufacturer or distributor for anyquestions or concerns. The Genie® Company is not responsible for any damage causeddue to an improperly braced door.C A U T I O NNote: One-Piece Door ( Top Edge/Face Mount) instructions are in the Operationand Maintenance Manual provided.6d 6d (alt) 6d (alt)Door centerline Door centerline Door centerline6a Attach no lower than top rollerDoor centerline Top Roller6